Equipment
Handheld Optical 3D Scanning Measurement System
• Measurement Method: Contact and Laser Scanning Probe
• Measurement Range: Diameter exceeding 2900 mm
• Measurement Accuracy: - E UNI: at least 0.031 mm - P SIZE: at least 0.012 mm - LDIA: at least 0.048 mm - PFORM: at least 0.025 mm
• 3D Scanning Probe: - Point acquisition frequency: up to 1,200,000 points per second or more - Accuracy when combined with an absolute articulated arm measurement system: below 0.138 mm - Enhanced accuracy when combined with an absolute articulated arm measurement system: below 0.047 mm.
• Phase 1: Two-Wheel Drive Motor System Test Platform
• Phase 2: Expansion into an All-Wheel Drive Motor System Test Platform
It is utilized for performance and reliability testing of electric axle systems, hybrid powertrains, fuel cell powertrains, pure electric powertrains, and powertrain components.
AVL RoadSim 72" MIM 4x4 Truck
The chassis dynamometer is designed to test front-wheel drive, rear-wheel drive, and four-wheel drive vehicles.
It is capable of testing commercial vehicles with either single or dual rear axles and operates in various control modes, including road load simulation, speed control, and traction control.
dSPACE
By integrating the 3D dynamic simulation software (ModelDesk) with parameter settings, real-time 3D animations, and system simulation hardware, data is directly read from the dSPACE hardware, allowing system performance to be displayed in the 3D virtual environment as efficiently as possible.
Through online real-time simulation, verification can be easily conducted prior to actual application.
It features 20 analog input channels with a 16-bit resolution, capable of measuring voltages from 0 to 60V, as well as 30 digital input channels.
It features 15 sets of 0-10V analog voltage output channels and 28 sets of digital output channels.
Mixed Signal Oscilloscope
Power input analysis software evaluates various parameters, including frequency, VRMS, IRMS, voltage and current crest factors, real power, apparent power, virtual power, power factor, phase angle, harmonics, surge current, and input capacitance.
This system offers optimal signal fidelity for the analysis and debugging of embedded systems operating at GHz clock and bus speeds. Bandwidth: 1 GHz; Sampling Rate: Instant - 12.5 GS/s for 8 channels fully open, 50 GS/s for 2 channels, 25 GS/s for 4 channels, and 2.5 TS/s for interpolation.
The 15.6-inch TFT capacitive touch (multi-touch) color display features an optimally designed viewing area that maximizes vertical space for waveforms while maintaining the highest ADC resolution at each input for the most accurate measurements.
120 kW Split DC Fast Charger for Electric Vehicles
Fast Charger (CCS1, CCS2, CHAdeMO)
Two electric vehicles can be charged simultaneously at high speed, allowing for the rapid charging of a single charging gun.
The input voltage is 380 VAC, the output voltage ranges from 200 to 750 VDC, and the output current is 200 A.
30 kW Wall-Mounted DC Fast Charger for Electric Vehicles
Fast Chargers (CCS1, CCS2, CHAdeMO)
Conform to the IEC international low-voltage DC charging interface standards.
The input voltage is 380 VAC, the output voltage ranges from 200 to 750 VDC, and the output current is 50 A.
Electric Locomotive 4.8 kW Light Electric Vehicle High/Low Power DC Charging Equipment
Fast DC Charging Equipment for Light Electric Vehicles
Conform to the IEC international low-voltage direct current charging interface.
The input voltage is compatible with 220 VAC and 380 VAC, while the output voltage ranges from 30 to 120 VDC, and the output current varies from 0 to 100 A.